Control Panel
①Sensitivity reduction adjustment
②Sensitivity enhancement adjustment
③4-level volume adjustment (including mute)
④2-level screen brightness adjustment
⑤Switch on/off
⑥Far/Near mode switching
Technical Parameters
Screen Size: 3.5 inch
Screen operation: press buttons
Receiver Frequency: 512Hz
Power consumption: <3W
Distance: about 5M/16.5FT
Battery: 3.7V 3000mAh built-in lithium battery
Charger: 5V0.5A
Charger time: about 6 hours
Battery Indicator: 5 bar
Battery working time: about 10 hours
Signal strength: 6 gear
Sensitivity Adjustable: Support
Speaker: Support
Detect Mode: Far/ Near
Survey the Area
① Install the antenna and turn on the locator.
② Press the "SEN+" button to adjust the sensitivity to the maximum value(7), you will hear the noise from the speaker (you can also adjust or turn off
the volume by pressing the "SOUND" button), and setting the mode to "Far".
③Hold the receiver and walk around the area where you want to estimate the location, slowly sweeping the receiver back and forth.
④ When the correct direction of the transmitter is detected, the signal will become stronger, otherwise, it will become weaker.
⑤ When the signal display is full, slowly reduce the sensitivity by pressing the "SEN-" button.
⑥Keep the receiver perpendicular to the ground and slowly move closer to the transmitter. When the sensitivity is adjusted to the minimum value (1)
and the signal display is still full, set the mode to "Near".
Detector Searches for Specific Locations
① Use the above steps to find the approximate location of the transmitter and switch the mode to "near".
② Press the "SEN+" button to adjust the sensitivity to the maximum value (7), hold the receiver, and slowly sweep the receiver back and forth within
the approximate location of the transmitter. The closer you get to the exact location of the transmitter, the stronger the signal will be, otherwise, it will become weaker.
③ When the signal is displayed as the strongest, slowly lower the sensitivity by pressing the "SEN-" button. When the sensitivity is adjusted to
the minimum value (1) and the signal display becomes the strongest, you can determine that this position is the specific location of the transmitter
Equipment Installation
1. Please align the antenna rod with the machine's card slot and insert it.
2. Then find a fastener from the package to tighten the interface.
Equipment Size
Antenna Length Size: 34.5cm/13.6in
Machine's Head Length Size: 15.0cm/5.8in
Total Length Size: 44.5cm/17.5in
Screen Size: 5.5cm/2.0in
Handle High Size: 11.5cm/4.5in
Machine's Head Total High Size: 21.5cm/8.5in.
Package List
1 * Plastic Box
1 * Locator
1 * Instruction Manual
1 * Fastener
1 * Charger
1 * USB-C Data Cable
1 * Earphones
